Chimney, gaskets, hinges and handle

Replace the chimney

Traeger support, "How to Replace a Chimney". Chimney kit KIT0005, cap KIT0008 and ring gasket KIT0795 are the same parts as the Pro 575's.

1. Make sure the grill is cold and unplugged.
2. Unscrew the cap.
3. Remove the 2 screws, holding the nuts inside the barrel if your grill has them.
4. Fit the new pipe with a new ring gasket between it and the barrel.
5. Refit the screws, washers and any nuts.
6. Screw the cap on with a 2 cm (3/4 in) gap.

Lid gap, hinges and handles

Traeger support.

1. Check the gap between the lid and the barrel: over 6 mm (1/4 in) is not normal.
2. Loosen the hinge screws, sit the lid square on the barrel, and retighten them.
3. If a hinge or the door stop is damaged, order the hinge kit (KIT0001) or right door stop (KIT0789).
4. Replace a damaged lid handle (KIT0146) or side lift handle (KIT0144) with its bolts and insulation washers.
5. Whenever the hopper is off, check the square hopper-to-barrel gasket and replace it if it crumbles (KIT0802).