Replace the floor temperature probe

Replace the floor temperature probe

The manual (p. 68). First check the plug is pushed fully onto its pins behind the display: a loose plug also shows ErS.

1. Let the oven go cold and disconnect the gas.
2. Slide the thermometer display out.
3. Unscrew the probe from the roof of the dock, under the stone, with a 10 mm spanner.
4. Screw the new probe into the same place.
5. Plug its cable into the thermometer board. For more room, take off the rear dock panel.
6. Refit the display, switch on and check the floor reading shows with no ErS.