Replace the air temperature probe

Replace the air temperature probe

The manual (p. 67). First check the plug is pushed fully onto its pins behind the display: a loose plug also shows ErA.

1. Let the oven go cold and disconnect the gas.
2. Slide the thermometer display out.
3. Unscrew the probe from inside the oven with a 13 mm spanner.
4. Feed the new probe's cable back through the oven and screw the probe in.
5. Find the cable inside the dock and plug it into the thermometer board. For more room, take off the rear dock panel.
6. Refit the display, switch on and check the air reading shows with no ErA.